Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco LMS and IDSM

Hello,

I can ssh from the CiscoWorks server into IDSM device. But when I 'Check Device Credential' thru device center, it is blank against ssh and 'Did not Try' for Enable By ssh.

Doing ssh into IDSM takes directly into the privileged mode.

Thanks.

10 REPLIES

Re: Cisco LMS and IDSM

LMS does not manage IDS devices.

IDSM is a software by the way for configuring your IDS.

If you are interested in IDS software, you can use CSM:

http://www.cisco.com/en/US/solutions/collateral/ns340/ns394/ns171/ns625/ns647/net_brochure0900aecd80400060.html

New Member

Re: Cisco LMS and IDSM

It is not only management. LMS provides a suite of features. And IDSM is supported by LMS. It is listed when device is added via the DCR (Common Services).

I would like to use the feature provided by LMS for IDSMs

Thanks.

Re: Cisco LMS and IDSM

What do you mean by IDSM?

This is not in the supported device list for LMS:

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/3.2/device_support/table/lms32sdt.html

IDS are supported by CSM as I said, and here is how you do it:

http://www.cisco.com/en/US/products/ps6498/products_tech_note09186a0080846d67.shtml

New Member

Re: Cisco LMS and IDSM

Ok.

If I go to the CiscoWorks LMS Portal, click Device Management under Common Services, and then click Add, and then expand Cisco Interfaces and Modules, and click Cisco Services Modules I can see the following two devices

1. Cisco Catalyst 6500 Series Intrusion Detection System (IDSM-2) Services Module

2. Cisco Catalyst 6500 Series Intrusion Detection System (IDSM-2) Services Module Virtual Sensor

and I can successfully add the device as well. Also, I can see the added IDSM devices in RME and DFM etc as well.

What does this mean then ?

Thanks.

Re: Cisco LMS and IDSM

Those devices are added in DCR for CSM to use them.

LMS can not provide you with monitoring for the IDS blades.

The support list for LMS has been made for this purpose: to list the devices that are supported.

New Member

Re: Cisco LMS and IDSM

So even if they are listed in DFM and RME due to adding into the DCR, would it not provide any additional features ?

Thanks.

Re: Cisco LMS and IDSM

Unfortunately not

New Member

Re: Cisco LMS and IDSM

Hello,

I am still having problems while detecting IDSM over ssh through DCR.

I can ssh from the CiscoWorks server into IDSM device. But when I 'Check Device Credential' thru device center, it is blank against ssh and 'Did not Try' for Enable By ssh.

Please assist.

Thanks.

Re: Cisco LMS and IDSM

Lms supports the devices listed in the device support list.

Yes you will keep on having problems with trying to use a not supported device.

New Member

Re: Cisco LMS and IDSM

I am only trying to add to the DCR (Common Services) where the device type - IDSM is shown. Shouldn't that be possible.

Thanks.

218
Views
0
Helpful
10
Replies