Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco LMS. Config Archive

Good day


Recently we've installed LMS 4.2. And also we've configured archive backup, but jobs weren't successfull. I'm getting error check credentials or increse timeout. But procedure of checking device credentials was successfull. I've checked onl ssh transport for archive is it correct?



Hall of Fame Super Silver

I assume you've verified your

I assume you've verified your vty transport and any access lists used on the target devices.

Given that, I'd go into Device Center and fire up a capture session for traffic from LMS to your switch and then run an on demand configuration sync for that one switch.

Examine the output in Wireshark (.jet file can be opened there) to see what's going on under the covers.

You could also watch your switch logs, possibly turning on debug for AAA.

New Member

Here is screenshots of check

Here is screenshots of check credentials and archive report

Can you tell please, how can i run debug for achive config?


Cisco Employee

This can be long to

This can be long to troubleshoot if you talk about various devices. You have to target device by device as reason of failure may differ for each device.

1. Run a job to archive config from a device and share the screenshot of result, if fail.

2. Share the DCMAService.log from server, also enable debug before you run the job for syncarchive.

3. Open device in Device centre and run a credential verification job to see if it succeeds.

4. Try to increase the timeout for telnet and read delay to almost double of what is configured.

Share the result once this is checked.




-Thanks Vinod **Rating Encourages contributors, and its really free. **