Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco LMS with ACE Module

Hello,

While adding Cisco ACE Module into DCR, the verification report says

1. SSH - OK

2. Enable by SSH - Enable Username credential missing.

I have added the enable password for ACE in DCR. What could be missing then.

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Cisco LMS with ACE Module

Leave the hostname field empty, and give the context a descriptive display name (e.g. HOSTNAME-context1).

7 REPLIES
Cisco Employee

Re: Cisco LMS with ACE Module

This could be a problem with how the ACE module is authenticating enable. If you SSH to this blade manually, then enable yourself, what prompts do you see?

New Member

Re: Cisco LMS with ACE Module

Ok. It goes directly into privileged mode without enable password via ssh access. Thanks.

If the ACE module has multiple contexts, how can it be configured in the DCR. Is it via different management IPs against the context.

New Member

Re: Cisco LMS with ACE Module

Please ignore. I got the whole config from the admin context itself.

Cisco Employee

Re: Cisco LMS with ACE Module

If you can do that, good. I know that ASAs and other multi-context firewalls require one to add each context for proper management.

Cisco Employee

Re: Cisco LMS with ACE Module

If it goes into privileged mode immediately, then don't choose to check enable by SSH in Device Credential Verification. RME should be able to fetch the config so long as it can become enabled using the current DCR credentials.

As for multiple contexts, yes, each context must be added to DCR by its own IP address.

New Member

Re: Cisco LMS with ACE Module

When I enter a new device for ACE 2nd context, the DCR reports 'Record for this device exist' while adding the device.

I have added different display name, IP for both the context. Only hostname is the same.

Cisco Employee

Re: Cisco LMS with ACE Module

Leave the hostname field empty, and give the context a descriptive display name (e.g. HOSTNAME-context1).

455
Views
0
Helpful
7
Replies