Cisco Net Assistant 5.5 not showing correcet timestamp in sys mess
In CNA Monitor/System Messages window, the timestamps are ahead by about 4 hours. All of the devices are NTP'd and are showing the correct time when executing 'sho ntp stat', my desktop is the correct time, but the application is not picking this up.
Any ideas as to why? I am running WinXP, and have tested it on an SP2 and an SP3 installation with the same results.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...