Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco Network Assistant 5.6(3)

Does anyone know if 5.6 supports SSH or SNMPv3 yet?  If not, does anyone have any clue if it ever will?

4 REPLIES
New Member

Cisco Network Assistant 5.6(3)

Don,

Have you gotten anywhere with this.  I'm looking for the same.  Thanks in advance!!

Hall of Fame Super Silver

Cisco Network Assistant 5.6(3)

The latest release notes still indicate this is an issue for ssh:

Cisco IOS Notes

Network Assistant fails when a device is running the cryptographic software image and the vty lines have been configured with the transport input ssh and line vty 0 15 global configuration commands only use SSH.

The workaround is to use the transport input ssh telnet and line vty 0 15 global configuration commands to allow SSH and Telnet access through the vty lines. After you upgrade to Cisco IOS 12.2(25)SE or higher, you can enable http or https separately from Telnet. (CSCdz01037)

New Member

Cisco Network Assistant 5.6(3)

Hey Marvin,

Thanks for the reply.  Any ETA on a fix/update?  Thanks in advance.

New Member

Cisco Network Assistant 5.6(3)

Hello,

I will look in to this for you and update the thread. I don't think we have a plan to make ssh-only work right now.

Out of curiosity, are you unable or unwilling to use cli over https?

Thanks, and thanks for using CNA!

1200
Views
0
Helpful
4
Replies