Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco Network Assistant MAC auth issue

I have few Autonomous Access Points all managed by the Cisco Network Assistant. Users have access to wireless only based on MAC authentication.

Every once in a while the wireless access to the Access-Point fails and the following error is showed in the Cisco Network Assistant.

ERROR: The MAC address filter 700 used for association access was not created by the web interface and cannot be displayed.

also

WARNING: Filter 700 was configured on interface Dot11radio 0.170 using CLI. It must be cleared via CLI to ensure proper operation of the web interface.

The Network Admin does not use CLI but this problem keeps coming. To fix this problem I had cleared the access-list 700 via CLI and created a new access-list 700 via Cisco Network Assistant. Adding all the MAC's each time the network goes down is a cumbersome process. Is there a solution for this?

Thanks in advance

error snapshot attached.

Everyone's tags (3)
644
Views
0
Helpful
0
Replies