I am running CNA 5.8. I have a situation where a device is discovered and is referenced on the left frame / Tree Diagram (in Topology View), BUT the device scrolls to the extreme corner of the right frame / Topology Map. I am unable to select and drag to a point where it is again visible. Most frustrating! Does anyone have a similar experience and a "fix"?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...