Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco Network Assistant

Hey Everyone,

I created a cluster on our Catalyst 3550 switch. We have around 30 2950-24T switches across our network. Unfortunately I can only have upto 16 switches in a cluster. Does anyone know the best way to over come this so I can have all my 30 switches under the one cluster?

Cheers,

Mark

1 REPLY
Silver

Re: Cisco Network Assistant

Make sure that all of the switches are connected using those ports in the same management VLAN. Access to all the cluster management facilities is through the command switch IP address. The command switch IP address always belongs to the management VLAN, which is VLAN1 by default.

All switches within the switch cluster must have the same management VLAN as the command switch.

117
Views
0
Helpful
1
Replies