I have a 4510R Device. Also some WS-C3750 Edge Switches connected to them. If I connect with the Cisco Network Assistant I cann see the 4510R Core Switch and all the C3750 Edge Switches. This is ok. But on the Edge Switches are connected some other C3750 Switches, and they are not visible with the Cisco Network Assistant over the 4510R. Just the first switch are visible, all other Switches connected to the Edge Switches are not visible. If I connect directly with the CNA to this Switches, all works. But I will see the whole Network over my Core Switch 4510R. Thanx alot
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...