Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Cisco PI 2.0 Monitor Configuration Threshold - Publish to Port group

Hi,

i have somewhat annoying problem with the monitor config threshold deployment. I want the Cisco Prime to generate an alarm when the traffic utilization on a specific interface goes over 90%. This is pretty straight forward to configure, problem is when i want to deploy this on only specific interfaces not whole devices. So i generate port groups, but when i should deply it no port groups are displayed:

2014-03-05 14-16-33.jpg

This is strange as i have defined several port groups. Why could be the reason that they do not show up here but devices and device groups works perfect? I have of course published the "Interface Health" to collect this information. Any ideas?

Cheers!

1 REPLY
New Member

Found this one myself.

Found this one myself. Obviously you need to deploy "Interface Health" on the port-group itself. It seems strange to me as you are already polling this information when you have deployed "Interface Health" on all devices, the port-groups are only logical groupings.
176
Views
0
Helpful
1
Replies
CreatePlease to create content