11-04-2014 11:04 AM
Hello
It is possible to take some show commands of a group in CiscoPrime 2.1 and then get this files?
Thanks for your help
Regards
Solved! Go to Solution.
11-12-2014 07:52 PM
Sure.
In Lifecycle mode you design a template (Design, Feature Design, CLI Templates). See the existing pre-configured templates for examples. Then create one with the commands you want and give it a useful name. (You can adapt the "Configure SNMP" template for example.)
The deploy it: Deploy, Configuration Tasks:
Templates > CLI Templates > System Templates - CLI > Configure SNMP
Choose your device group, site group etc. as targets and then deploy.
11-04-2014 03:12 PM
I don't think so. This is a feature that was available in Prime LMS that has not yet been ported into PI.
11-12-2014 08:57 AM
Thanks Marvin for your response.
And what about to make some changes in configuration of a group, for example
It is possible to do whatever templet I want for a group in prime infraestructure 2.1?
Thanks for your help
Regards
11-12-2014 07:52 PM
Sure.
In Lifecycle mode you design a template (Design, Feature Design, CLI Templates). See the existing pre-configured templates for examples. Then create one with the commands you want and give it a useful name. (You can adapt the "Configure SNMP" template for example.)
The deploy it: Deploy, Configuration Tasks:
Templates > CLI Templates > System Templates - CLI > Configure SNMP
Choose your device group, site group etc. as targets and then deploy.
11-13-2014 11:44 AM
Thanks Marvin
I did that and Its works
regards
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: