I'm trying to deploy a configuration by Cisco Prime Infrastructure v1.2:
The config that I want to deploy (is a test) is the following:
conf t ! interface GigabitEthernet1/0/37 no switchport port-security no switchport port-security aging time 5 no switchport port-security violation restrict no switchport port-security aging type inactivity no switchport port-security maximum 3 shutdown no shutdown
The result of failed operation is: IFM Config | CA Backup failed before deploy template test_portsecurity to 172.18.8.26
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...