Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco Prime Infrastructure HA - HA Mode Change

I'm in the process of configuring a new Cisco Prime Infrastructure HA pair, but the server which was to be the secondary was accidentally configured as stand-alone. Is it possible to change this to the secondary in an HA pair after it has already been configured? I have been unable to find any commands via CLI or GUI that would allow me to configure this device as a secondary HA server. I'd prefer not to have to rebuild the whole server, but it's starting to look like I may have to.

1 REPLY
Cisco Employee

Hello,If you don't want to

Hello,

If you don't want to start again then you need to contact TAC , they can engage BU . they know how to make it in HA setup even after  the installation of secondary server as standalone.

 

**there is no direct way to do this , some properties files and config need to be changed

 

Thanks-

Afroz

*****Ratings Encourages Contributors ***

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
119
Views
0
Helpful
1
Replies
CreatePlease login to create content