Cisco Prime Infrastructure (NCS) planning mode with non-rectangular building
How can I run planning mode in Cisco Prime Infrastructure (maps) with a building that is non-rectangular? It places AP's outside the coverage area. I have also tried excluding the outdoor area on the map.
Adjust the size or placement of the rectangle by selecting the edge of the rectangle and holding down the Ctrl key. Move the mouse as necessary to outline the targeted location. When you use the next-generation maps mode, the rectangle is resizable by dragging on the handles on its edges and corners.
Thank you for your response. The building I am planning for is a U shape with the part in the middle being exterior. We do not want to install outdoor AP's but with the directions you provide I can only change the size of the rectangle, not the shape. Is my only option to remove the access points shown outside?
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...