Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

CISCO PRIME LMS 4.1 ---- Software distribution fails with SWIM1113

Device will be rebooted.
SWIM1113: Device Reboot operation failed or Reboot Verification failed.
The device is not running the new image after it is rebooted.
Verify the configuration used to load the new image. Verify whether the new image exists on the device in a valid Flash partition

 

the software distribution , i select image  for upgrade for router 1841  and select reboot immediatly after downloading so my device take new image but can not reload with new image ...

 

please help me

3 REPLIES
Cisco Employee

check if you have this

check if you have this command configured on the device ::snmp-server system-shutdown

if not configured it and it should reload it

 

Thanks-

Afroz

****Ratings Encourages Contributors ***

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****

thanks for answer , but  this

thanks for answer , but  this command use for reboot device with snmp . and i dont problem with reboot device ,, and my problem is device can not load new image after reboot  . and i used this command ...

 

 

Cisco Employee

Hi, Kindly enable the

Hi,

 

Kindly enable the debugging fro SWIM (admin>debug settings)

re-run the job and share the swim_debug.log (NMSROOT/CSCOpx/log)

and Job log.

 

Thanks-
 

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
92
Views
0
Helpful
3
Replies
CreatePlease login to create content