Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco Prime LMS 4.2.2 syslog filter syntax?

I am running the software appliance version of Cisco Prime LMS 4.2.2.  I have a syslog Automated Action that sends out an email notification for any severity 0, 1, or 2 messages.  Recently I found out that when a Cisco 2960 crashes, it logs 35 messages that form a report, all at severity 1.  I want to get 1 email for this and not 35.  My first thought is to use a syslog filter to drop most of the messages except for 1.  It looks like the definition of a syslog filter has some regular expression capability that would help in this case, but I can't find a description of it anywhere.  What is the syntax of the regular expression capability of a syslog filter???

Thanks for any help.

Dave

Everyone's tags (2)
2 REPLIES
Cisco Employee

Re: Cisco Prime LMS 4.2.2 syslog filter syntax?

Hi Dave,

If your need is to get notification for only SEV 1 messages then you can create a filter for it and rest all you can Drop.

go to

Admin > Network > Notification and Action Settings > Syslog Message Filters.

Attached is screenshot for the same. you futher can specify the mnemonics and facility as well ,if you want otherwiese SEV is fine

hope this will help you.

Thanks-

Afroz

[Do rate the useful post]

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
New Member

Re: Cisco Prime LMS 4.2.2 syslog filter syntax?

Hi Afroz,

Thank you for your response, but what you described is not what I am looking for.  I only want to drop a particular set of severity 1 messages, not all of them.

314
Views
0
Helpful
2
Replies