Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Cisco Prime LMS 4.2.2 SystemComplianceCmdCollection job

There is an expired evaluation license for the "PI-CM" feature in LMS.  How do I stop the SystemComplianceCmdCollection job from running since it never runs properly without the license?                  

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Cisco Prime LMS 4.2.2 SystemComplianceCmdCollection job

Hi ,

Can you try the below steps:

1) Open a command prompt and go to C:\Progra~1\CSCOpx\bin

2) Issue the command:

cwjava -cw C:\Progra~1\CSCOpx com.cisco.nm.cmf.jrm.jobcli

3) It will take you to the Job CLI mode. Now give the command:
delete   and type the number of the job you want to delete.

for you it is :: delete 6690

It should look something like this: cwjava -cw C:\Progra~1\CSCOpx com.cisco.nm.cmf.jrm.jobcli Established connection with JRM Enter "exit" to quit the CLI delete 1112 Job 1112 deleted. exit

Thanks-
Afroz
[Do rate the useful post]
****Ratings Encourages Contributors ****

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
2 REPLIES
Cisco Employee

Cisco Prime LMS 4.2.2 SystemComplianceCmdCollection job

Hi ,

Can you try the below steps:

1) Open a command prompt and go to C:\Progra~1\CSCOpx\bin

2) Issue the command:

cwjava -cw C:\Progra~1\CSCOpx com.cisco.nm.cmf.jrm.jobcli

3) It will take you to the Job CLI mode. Now give the command:
delete   and type the number of the job you want to delete.

for you it is :: delete 6690

It should look something like this: cwjava -cw C:\Progra~1\CSCOpx com.cisco.nm.cmf.jrm.jobcli Established connection with JRM Enter "exit" to quit the CLI delete 1112 Job 1112 deleted. exit

Thanks-
Afroz
[Do rate the useful post]
****Ratings Encourages Contributors ****

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
New Member

Cisco Prime LMS 4.2.2 SystemComplianceCmdCollection job

Hi,

Thank you!  Yes, that works.  I adjusted it for the Soft Appliance Linux commands like this:

[system1/root-ade ~]# cd /opt/CSCOpx/bin
[system1/root-ade bin]# cwjava -cw /opt/CSCOpx com.cisco.nm.cmf.jrm.jobcli 
Established connection with JRM
Enter "exit" to quit the CLI
delete 6690
Job 6690 deleted.
exit
[system1/root-ade bin]#

Regards,

Dave Faught

288
Views
5
Helpful
2
Replies
CreatePlease to create content