Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

cisco prime ncs on windows hyperv

Can cisco prime network control control system server v 1.x be installed on windows hyperv?                  

Everyone's tags (5)
2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Silver

cisco prime ncs on windows hyperv

Sorry, no. See the Getting Started Guide:

If deploying NCS as a virtual appliance on a customer-supplied server, one of the following versions of VMware ESX or ESXi may be used:

VMware ESX or VMware ESXi version 4.0

VMware ESX or VMware ESXi version 4.1

VMware ESXi version 5.0

Hall of Fame Super Silver

cisco prime ncs on windows hyperv

The current NCS offering can be purchased as a physical appliance from Cisco with the software pre-installed or you may purchase it as a virtual appliance to be run as a guest on a VMware ESX or ESXi 4.0, 4.1 or 5.0 server as noted above.

You cannot install it on a Windows 2008 or Linux server. (The ADE-OS on which the application server runs is built on a Linux distribution but hacking the build to run on your own Linux server would not be a supported (or likely consistently functional) installation.)

Hope this helps. Please rate helpful posts.

4 REPLIES
Hall of Fame Super Silver

cisco prime ncs on windows hyperv

Sorry, no. See the Getting Started Guide:

If deploying NCS as a virtual appliance on a customer-supplied server, one of the following versions of VMware ESX or ESXi may be used:

VMware ESX or VMware ESXi version 4.0

VMware ESX or VMware ESXi version 4.1

VMware ESXi version 5.0

New Member

cisco prime ncs on windows hyperv

Thanks for the reply.

May NCS be installed on a stand alone windows 2008 server?

New Member

cisco prime ncs on windows hyperv

Or a stand alone Linux instance?

Hall of Fame Super Silver

cisco prime ncs on windows hyperv

The current NCS offering can be purchased as a physical appliance from Cisco with the software pre-installed or you may purchase it as a virtual appliance to be run as a guest on a VMware ESX or ESXi 4.0, 4.1 or 5.0 server as noted above.

You cannot install it on a Windows 2008 or Linux server. (The ADE-OS on which the application server runs is built on a Linux distribution but hacking the build to run on your own Linux server would not be a supported (or likely consistently functional) installation.)

Hope this helps. Please rate helpful posts.

1803
Views
0
Helpful
4
Replies
CreatePlease login to create content