I am adding my Cisco 3750's into prime and I would like to enable NMSP fro each switch using prime.So far I have only found the way to do this is by editing each switch once Prime has synchronizing with the switch. Is there away to do this in bulk? I have hundreds of these switches and it would take me for ever to do each...
What you're asking about can usually be handled via a template. You can use either one of the pre-configured ones (adapting it if it doesn't quite fit your need) or create a cli template from scratch. Here is a link to the documentation section showing how that's done.
Once you have a template, you simply deploy it to your switches. You can choose all of a certain model or place them ones you want into a group and deploy the template to the entire group.
If you'd like to see it in action and get some more information, please have a look at this YouTube video that Eric and Tomer from the business unit demonstrate this feature.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...