Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco RME Netconfig

Hi all,

I am using CiscoWorks RME 4.0 Netconfig to push some config.  I am creating a new Netconfig job.  After selecting a device (2621XM), I selected my user-defined SSH task.  It didn't show up on the next screen under "Applicable Tasks".  However, if I chose the system defined SSH task for the same device, the system defined SSH task showed up.

Why is my user defined task not showing up?

Thanks!

1 REPLY
New Member

Re: Cisco RME Netconfig

Never mind, I found out where the problem is.  Under user defined task, you can choose device type to apply the task to.

158
Views
0
Helpful
1
Replies
CreatePlease login to create content