Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco Security Manager: how to add "dialer pool-member" in ATM interface

Hello,

I have a ISR 1801 with an ADSL interface.

Do you know where I can add dialer pool-member configuration for an ATM interface in CSM ?

I've tried lost of things including a config discovery without success.

CSM is always deleting this line. And the realtime result is always the same:

bye-bye router (needs to reboot it to restore original configuration).

Any idea ? (except stop using the bugy CSM)

Thanks,

NH

  • Network Management
1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Cisco Security Manager: how to add "dialer pool-member" in A

1. Enters interface configuration mode for the ATM interface.

2. Creates an ATM PVC for each end node (up to ten) with which the router communicates. Enters ATM virtual circuit configuration mode. When a PVC is defined, AAL5SNAP encapsulation is defined by default.

3. Specifies the ATM interface as a member of a dialer profile dialing pool. The pool number must be in the range of 1-255.

1 REPLY
Silver

Re: Cisco Security Manager: how to add "dialer pool-member" in A

1. Enters interface configuration mode for the ATM interface.

2. Creates an ATM PVC for each end node (up to ten) with which the router communicates. Enters ATM virtual circuit configuration mode. When a PVC is defined, AAL5SNAP encapsulation is defined by default.

3. Specifies the ATM interface as a member of a dialer profile dialing pool. The pool number must be in the range of 1-255.

134
Views
0
Helpful
1
Replies
This widget could not be displayed.