I discovered that anytime the Uplink of my Cisco C2960CG-8TC-L goes down and reconnects, before the switch connects with the Radius Server, the access ports starts to connect into Guest VLAN, which is not the correct production VLAN that has been assigned to the Mac addresses.
I thought I could resolve this with Link state track Upstream and Downstream, but it's not working effectively.
The solution to the problem should be when the UPLINK port does down for whatsoever reason and comes back up, it should communicate with the Radius Server first, thereafter the access ports comes up and connect to the assigned Production VLAN not the Guest VLAN.
How do I achieve this? Any positive advise would be highly appreciated. Configuration can be uploaded if needed.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...