CiscoView is not showing the sup module in Cisco 4507R-E. Please see attached.
I have Cisco 4507-R-E with SUP6LE- In 4507 you put SUP module in slot3 and 4 and I have sup in slot 3 (slot 4 is empty). I can lauch the switch in Cisco View but sup is not showing. I see that CiscoView labels SUP module in slot 1 which is also incorrect.
I see this same behavior in Cisco 4506R-E with SUP6-LE. Please advise.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...