Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

cisco View ans UT one LMS 2.6

on Cisco view the port showing green but no user report on the port. is this because the device attached to the port is unknown by Ciscoworks? the second one the UT report the device attach to the port but ciscoview

show as Dormant on the port. what's really mean? thank you in advance for your help.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: cisco View ans UT one LMS 2.6

User Tracking just shows end hosts (e.g. PCs) and IP phones. Campus Manager Topology is designed to track routers, switches, and APs.

3 REPLIES
Cisco Employee

Re: cisco View ans UT one LMS 2.6

User Tracking ignores MAC addresses on trunk ports and ports which make up links on the topology map. It could be that this particular port falls into one of those two categories. Additionally, if this is a layer 3 device, and the port in question is in layer 3 mode, then UT will ignore that port.

UT retains data it found in previous acquisitions. So the port could have been active at one point, and now it is dormant.

New Member

Re: cisco View ans UT one LMS 2.6

thanks a lot. simple related question. user tracking is not tracking switch, router or Access point? is that right?

Eli

Cisco Employee

Re: cisco View ans UT one LMS 2.6

User Tracking just shows end hosts (e.g. PCs) and IP phones. Campus Manager Topology is designed to track routers, switches, and APs.

96
Views
0
Helpful
3
Replies