Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco View error for 3845 router

Hi

LMS version 2.6 CISCO VIEW VERSION 6.1.5

we have installed Rtr3800.cv50.v8-0.zip

also we have copied missing pkgRtr3800.cv50.v8-0.zip)

FROM NMSROOT/www/classpath/com/cisco/nm/xms/psu/pkgs/cvw

TO NMSROOT/MDC/tomcat/webapps/CVng/WEB-INF/classes/com/cisco/nm/cvw/devpkgs, Than restarted demon services

but getting this below error message

Message

Can't find applicable device package for 172.16.254.46.

Cause

Device package for this device type is not installed or device support for this device type might not be available or you are attempting to open a component inside a device.

Plse let me know the solution

Regards

Vaibhav

2 REPLIES
Cisco Employee

Re: Cisco View error for 3845 router

If you had to manually copy the package, then something is not right in your installation. You may be missing other required packages. Make sure you also have NGMARShare.cv50.v1-7.zip properly installed.

Also, make sure the permissions on the packages allow for casuser to have full control.

Also, what is the sysObjectID of 172.16.254.46? It may be that this device is not supported by this package.

New Member

Re: Cisco View error for 3845 router

Hi Clark

I have resolved the issue by just renaimimg the (Rtr3800.cv50.v8-0.zip).

to Rtr3800.zip than it sync and now i am able to see cisco view.

Thanks

Regards

Vaibhav

154
Views
0
Helpful
2
Replies