Cisco WOrk RME Looking for all the IOS version at one goes

[mcnaz-yeo]

Hi,

can any one advise at which tab can i view all my cisco devices wiht the IOS version they are in, another question which version of cisco work rme suport 3550. I just cant view it via campus viewer

Regards

Mc

[getwithrob]

I'm not sure which version of CiscoWorks you are using but in LMS 2.2 (RME 3.5), you would need to run a software inventory report to see which version of code the 3550s are on.

I would say most versions of RME support 3550 IOS switches.

Another question might be: what do you want to do with the 3550? backup the configs, run inventory (hw/sw) reports, be able to discover it in Campus Mgr, be able to pull a graphical view with CiscoView? or what?

[mcnaz-yeo]

Thanks I got your answer on my first question

Hmm My second question was I am not able to pull graphical view with CiscView and encounter time out where likely the problem will be. Please advise

Regards

NC

[getwithrob]

Is snmp setup correctly on the 3550?

Can you snmpwalk the device?

Do you have the most current package(s) installed that supports the 3550?

[mcnaz-yeo]

the snmp should be correct. btw I think U should be using the most curreny packages . what is your version now >

[getwithrob]

LMS 2.2, RME 3.5, CiscoView 5.5 is what is runing here now. Is it the most current version of LMS and RME? No.

I have a Catalyst 3550-24 SMI running Version 12.1(22)EA1.

These are the packages for the 3550s.

Cat3500XL 4.0 Cat3500XL device package

Cat3550 8.0 Catalyst3550 device package

CiscoView works fine for me.