We having single network total 3 L3 switches in server mode and 80 L2 transperent and claint modes switches, Total switches are same vtp ,L3 ip address 10.66.1.1,1.60 and 1.120,on cisco works topology services showing only 10.66.1.60 switch details and some other switches showing but it s not showing total network,I configured on cisco works snmp settings . any other configuration required.all switches are enabled cdp .Total Network 10.66.1.0 series.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...