Your best bet is to configured a Change Audit automated action to send email on configuration changes. These actions can be configured under RME > Tools > Change Audit > Automated Actions. Choose All for Application, Mode, and User, and CONFIG_CHANGE for category.
Whenever RME detects a config change, an email can then be sent. By using Change Audit, you'll know when configuration changes were made directly on the device as well as through RME.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...