Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco works assistant 1.1 with LMS 3.1

Hello,

Setting a default credentials in ciscoworks assistant is compulsary before discovering devices in LMS 3.1.

For example primary username & password & enable password. OR

In common services if i dont select any protocol in discovery module and any seed device except snmp settings will LMS would be able to discover???

Thnaks

3 REPLIES
Cisco Employee

Re: Cisco works assistant 1.1 with LMS 3.1

Setting up default credentials is NOT required. You can simply configure some SNMP credentials in Discovery directly or through CWA, then Discovery will work.

New Member

Re: Cisco works assistant 1.1 with LMS 3.1

Hi,

Then for what purpose the primary credentials & secondary credentials & enable secret is used for.

while discovering some of the devices are unreacheable but actually they are reacheable from ur previous archives i have seen discovery issues that u have mentioned that cheked with SNMP for reacheability,by doing SNMPwalk or packet capture

Can i do a snmpwalk from my LMS 3.1 portal or advice me for any third party software for snmpwalk.

Cisco Employee

Re: Cisco works assistant 1.1 with LMS 3.1

The other credentials are used for other applications. For example, the username and password credentials are used by RME to fetch and deploy device configurations and software images. The read-write community string is used by applications such as RME, Campus, and IPM.

You can do an SNMP Walk from Device Center.

123
Views
0
Helpful
3
Replies