Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Cisco Works Autodiscovery

Hello,

Please, how can I configure CiscoWorks LMS 2.6 for auto-discovery?. What is the module that I need to configure?

Tks.

4 REPLIES
Cisco Employee

Re: Cisco Works Autodiscovery

Hi.

You can configure discovery of your network devices through Campus Manager.

This is when the online help will be very helpful to you. So, I think the best way for you to proceed is to go to Campus Manager -->Administration and then click "help" in the upper-right corner of the screen. That will bring up the online help and should have everything you need there to set-up discovery.

If you have any questions after this, please post them here and I'll be happy to assist.

Regards,

-Joe R.

Re: Cisco Works Autodiscovery

Thank you Joe, I'll search this option and I'll apply it.

Cisco Employee

Re: Cisco Works Autodiscovery

If you don't have any devices in the DCR already, you'll want to add some seed devices in Campus Manager.

The following white paper is for LMS 2.5, but has all you need for 2.6:

http://www.cisco.com/application/pdf/en/us/guest/products/ps2425/c1244/cdccont_0900aecd8026ee8d.pdf

Scroll to the section Defining a Seed device in Campus Manager. It also has info on all configurations needed on the devices.

Re: Cisco Works Autodiscovery

Thank you davistan, I'll search this information and I'll apply it.

331
Views
10
Helpful
4
Replies