I've just upgraded from Ciscoworks LMS 2.2 to 2.6. When I try to launch Ciscoworks it takes me to a web page that says "Server Not Ready Please wait...system is still coming up You will be redirected to a login page soon" The page will refresh every 10 seconds or so but it never goes to a login or anything. It's been at least an hour and all of the Ciscoworks related services appear to be started. I don't have anything in the Windows EventViewer that looks suspicious. What's my next step?
Check your CiscoWorks service startup parameters, and make sure that the only ones that are set to automatic are CiscoWorks Daemon Management, RCP, RSH, TFTP, and the IPM services. The rest must be set to manual. If anything needed changing, reboot the server.
If the services are correct, run "pdshow Tomcat" and make sure it is running. In either case, the NMSROOT\MDC\tomcat\logs\stdout.log should have more information.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...