I recently noticed a fault in the device fault manager-monitoring console that states that a particular switch is unresponsive. The error further states that the ServiceAccessPoints on the system are not responding. I have noticed that the switch is up and running and the users at that location have not complained of any outages. I've also checked the logs and noticed nothing abnormal. I am not really sure of what a ServiceAccessPoint is and was hoping I could gain some insight if at all possible. Thanks for your help in advance.
The serviceaccesspoint is a boolean used by the DFM administration console. If the sericeaccesspoint is not responsive an error will show up on DFM, but if your device is operational and you are still getting the error then i do not know.
A service access point describes a logical endpoint that can be used to gain access to some network service. Important service access points are IP,
which represents the point at which an IP address can be reached; and Media Access Control (MAC), which similarly represents the point at which
a Layer 2 address can be reached. Layer 3 service access points are often described as logical nodes.
I was hoping you could tell me more about which Service Access Point was reported unresponsive. I understand that such information might be classified. Thus, I'll just try to make some assumptions.
Assuming the Service Access Point reported as unresponsive was an IP address, a common cause for this was an unused interface on a router which has an IP address configured. To resolve this issue, remove the IP address configuration from the router and rediscover the device from DFM.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...