I have a small issue with my CiscoWorks. My company has an old version of CiscoWorks 2000 with RME 3.3, DFM 1.1, CDone 4th Edition and so on. I think it was purchased around 4 to 5 years back. My company is keen on using it for time being, once they are satisfied about its perfomance then they would go for the latest version. The problem is I could not find any relevant decumentation about its installation and configuration and fine tuning. Any help on this will be highly appreciated. The Server I will be using is having 2GB RAM, I think that would be enough i suppose.
Thank you very much. I know it will be difficult for me if I get stuck in any problems while configuring it, since its not supported now. But still i hope these links to the documentation will be helpful.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...