Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Ciscoworks 3.0 rechability check fails.

Hi friends,

The reachability check fails while checking in Ciscoworks but there is no reachability issue as such. The credentials are also fine. But still the devices are not being imported to DFM / RME.

Screenshots attached.

Regards,

Rajiv

3 REPLIES
Cisco Employee

Re: Ciscoworks 3.0 rechability check fails.

The biggest problem here is the lack of SNMP connectivity.  Verify that your SNMP credentials in DCR are correct.  If they are, check the device to make sure the LMS server is allowed to poll it with SNMP.

Re: Ciscoworks 3.0 rechability check fails.

The devices have snmp-server host configured too. But then too there are issues. I also noticed that while deleting some of the learning devices in DFM rediscovery/delete, the devices got stuck as pending devices and were not getting deleted even after hours.

May be reinstallation of the DFM will resolve the issue. Could you please suggest any things that i need to check?


Best Regards // Rajiv

Cisco Employee

Re: Ciscoworks 3.0 rechability check fails.

Exactly what version of DFM do you have?

198
Views
4
Helpful
3
Replies