Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

CiscoWorks: Adding device in CS but it's in pending devices in RME.

Hi,

I have fresh installed the LMS 3.2.1 without any errors. Then I am adding device in CS, give it correct credentials. Its appears in RME automatically, but it always remain in Pending devices in RME.

I have run a job in RME to check the devices credentials and it's appearing that credentials for snmp are wrong but ssh/ telnet appears as "did not try". Although I have added the correct credentials in CS for device, but it appearing as wrong in RME.

Also when I add device in CS, it's not automatically picking it's device type, until in CS I define its device type manually.

Please advise a solution for thiss problem.

Thanks

2 REPLIES

CiscoWorks: Adding device in CS but it's in pending devices in R

This usually indicates that SNMP contact to the devices fails

I use the CLI tools like \CSCOpx\objects\jt\bin\snmpwalk.exe to check this.

Cheers,

Michel

New Member

Re: CiscoWorks: Adding device in CS but it's in pending devices

Thanks

Sent from Cisco Technical Support iPhone App

594
Views
0
Helpful
2
Replies
CreatePlease to create content