Ciscoworks: Back restore procedure?

[raza555]

Hi,

We are relocating ciscoworks on same server from c to e: drive, with new installation on e:drive. Our backup is alread Saved in below folder of e: drive

E:\backupFile\0\ here are all databases folders e.g.rmeng,cmf etc.

Please tell me the cli command restore backup from this location, is it possible to type 1 command to restore all databases/full back file, or I have to restore each database seperatly. I prefer 1 command to restore everything.

We are using LMS 3.2.1

Please also advise that can I directly install LMS 3.2.1 on e: drive, or I have to 1st install LMS 3.2 then LMS 3.2.1

If it's possible to directly install LMS 3.2.1, then please tell me file location 

Thanks

[Martin Ermel · Accepted solution]

LMS 3.2.1 is just a service pack for LMS 3.2, thus you have to install LMS 3.2 and then you have to apply the service pack to get LMS 3.2.1;

after uninstallation of LMS 3.2.1 from C:\ do not forget to reboot the server;

here is the Data Migration Guide for LMS 3.2.1 - and yes you can restore all databases with one command (I assume you will install the same application you had before):

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/3.2/SP1/Readme/Readme__LMS_3.2_SP1.html#wp160195

and the link for the restorebackup.pl syntax:

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/3.2/data_migration/guide/rsbkppl.html#wpxref31256