Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Ciscoworks: Back restore procedure?

Hi,

We are relocating ciscoworks on same server from c to e: drive, with new installation on e:drive. Our backup is alread Saved in below folder of e: drive

E:\backupFile\0\ here are all databases folders e.g.rmeng,cmf etc.

Please tell me the cli command restore backup from this location, is it possible to type 1 command to restore all databases/full back file, or I have to restore each database seperatly. I prefer 1 command to restore everything.

We are using LMS 3.2.1

Please also advise that can I directly install LMS 3.2.1 on e: drive, or I have to 1st install LMS 3.2 then LMS 3.2.1

If it's possible to directly install LMS 3.2.1, then please tell me file location 

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions

Ciscoworks: Back restore procedure?

LMS 3.2.1 is just a service pack for LMS 3.2, thus you have to install LMS 3.2 and then you have to apply the service pack to get LMS 3.2.1;

after uninstallation of LMS 3.2.1 from C:\ do not forget to reboot the server;

here is the Data Migration Guide for LMS 3.2.1 - and yes you can restore all databases with one command (I assume you will install the same application you had before):

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/3.2/SP1/Readme/Readme__LMS_3.2_SP1.html#wp160195

and the link for the restorebackup.pl syntax:

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/3.2/data_migration/guide/rsbkppl.html#wpxref31256

1 REPLY

Ciscoworks: Back restore procedure?

LMS 3.2.1 is just a service pack for LMS 3.2, thus you have to install LMS 3.2 and then you have to apply the service pack to get LMS 3.2.1;

after uninstallation of LMS 3.2.1 from C:\ do not forget to reboot the server;

here is the Data Migration Guide for LMS 3.2.1 - and yes you can restore all databases with one command (I assume you will install the same application you had before):

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/3.2/SP1/Readme/Readme__LMS_3.2_SP1.html#wp160195

and the link for the restorebackup.pl syntax:

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/3.2/data_migration/guide/rsbkppl.html#wpxref31256

436
Views
5
Helpful
1
Replies