Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Ciscoworks - Database Ad-hoc Retrieval

I am trying to use the Ad-hoc Retrieval page on our Ciscoworks (LMS 2.6) implementation. I have been getting the failed login (bad username/password) message when attempt to pull table data.

I have tried the default (sa/c2kY2k) but I get the same results.

The /rmeng/orig/odbc.tmpl file contains a CWUID and CWPWD but they do not work (I'm assuming they are encrypted).

Any ideas or other password combinations for the database?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Ciscoworks - Database Ad-hoc Retrieval

This tool is not supported for customer use. Changes to the database using this tool could require you to reinitialize your database, thus causing data loss.

That said, the database passwords are random in LMS 2.6. You can use the NMSROOT/bin/dbpasswd.pl utility to set the database password to a known value.

1 REPLY
Cisco Employee

Re: Ciscoworks - Database Ad-hoc Retrieval

This tool is not supported for customer use. Changes to the database using this tool could require you to reinitialize your database, thus causing data loss.

That said, the database passwords are random in LMS 2.6. You can use the NMSROOT/bin/dbpasswd.pl utility to set the database password to a known value.

244
Views
0
Helpful
1
Replies