Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ciscoworks device packages

Is there a device package for mds 9000 cisco switches which will allow ciscoworks to manage my mds 9120's. I'm pretty new to ciscoworks and just getting used to it but when I try to run ciscoview and select my 9120 device it says It doeesn't have the applicable devic package installed. I have looked at adding the device packages but can't see any which would support MDS 9000 range.

I am running ciscoworks ciscoview version 5.5

and this is my switch

Cisco Storage Area Networking Operating System (SAN-OS) Software

TAC support: http://www.cisco.com/tac

Copyright (c) 2002-2005, Cisco Systems, Inc. All rights reserved.

The copyrights to certain works contained herein are owned by

other third parties and are used and distributed under license.

Some parts of this software are covered under the GNU Public

License. A copy of the license is available at

http://www.gnu.org/licenses/gpl.html.

Software

BIOS: version 1.1.0

loader: version 1.2(2)

kickstart: version 2.1(2b)

system: version 2.1(2b)

BIOS compile time: 10/24/03

kickstart image file is: bootflash:/m9100-s1ek9-kickstart-mz.2.1.2b.bin

kickstart compile time: 8/30/2005 19:00:00 [09/18/2005 19:47:18]

system image file is: bootflash:/m9100-s1ek9-mz.2.1.2b.bin

system compile time: 8/30/2005 19:00:00 [09/18/2005 20:07:26]

Hardware

cisco MDS 9100 ("1/2 Gbps FC/Supervisor")

Intel(R) Pentium(R) III CPU - with 964000 kB of memory.

Processor Board ID JAB093400VV

bootflash: 500736 blocks (block size 512b)

slot0: 0 blocks (block size 512b)

mensa kernel uptime is 64 days 21 hours 42 minute(s) 37 second(s)

Last reset at 460859 usecs after Wed Dec 14 15:22:16 2005

Reason: Reset Requested by CLI command reload

System version: 2.1(2b)

Service:

Any help would be appreciated

Cheers

Gordon

1 REPLY
Red

Re: ciscoworks device packages

The MDS switch line is not supported in CiscoView, as there is an equivalent management application that is embedded on the switches and works in tandem with the MDS Fabric Manager.

341
Views
0
Helpful
1
Replies
CreatePlease to create content