Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our beta test area to get started.

New Member

CiscoWorks DFM 2.0.6 support for 2924XL and 3548XL

Hi all,

2924XL and 3548XL are listed with Partial support in DFM 2.0.6 release notes.

Has anyone seen any more specific documentation regarding the limitated support? Experiences from other installations?

What can DFM monitor?

From the release notes:

1. ?Partial DFM support? indicates DFM will manage the device but may not report all device attributes because (1) the device operating system does not

support one or more of the MIBs polled by DFM, and/or (2) the device MIB contains information that is not correctly populated.

  • Network Management

Re: CiscoWorks DFM 2.0.6 support for 2924XL and 3548XL

This is due to limitations of the switches themselves. For example, the XL series switches do not (and never will) support the CISCO-ENVMON-MIB. Thus DFM will not be able to report on the temperature of the XL series switches.

DFM will be able to report on the basic SNMP information, such as link down.


Re: CiscoWorks DFM 2.0.6 support for 2924XL and 3548XL

Hi Frederik,

i had similiar issue with a 3524XL and the IOS 12.0(5)WC13. I have upgraded from 12.0(5)WC11 to 12.0(5)WC13 and got this problem. I could not do a snmpwalk and or reach the device vie snmp from the LMS. I guess the snmp agent was bugg.

After downgrading to 12.0(5)WC12 everything went fine again. Actual i run 12.0(5)WC15 without any issues.

Have a look here to see what MIBs are polled.

Best regards,


Best regards,