The time interval depends on how often your poller runs, and when it was created. For example, if you create a default five minute poller at 12:30, then it will run at 12:35, 12:40, 12:45, etc.
Yes, all reports are based on the data retrieved by the poller. The device report is an amalgamation of all poller data for the various built-in templates.
Data can be retained on a configurable basis. The data purge settings can be found under HUM > Admin > Data Purge. By default, the 12 hour summarization data is kept for a year. But there are a lot of data purge metrics that can be configured.
As long as the data exists in HUM, you can access it via the HistoGraphIt portlet, or via reports.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.