Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Ciscoworks interaction with NETACT

I need to change Ciscoworks default thresholds to some devices of my network because it sends too many alerts through a third party software. I have created a new "device group", customized "thresholds", generated an "Alert View", created a new "Event set" and created a new "Notification group". These alerts and events need to be sent by SNMP traps to a specific IP address. I am not sure if after these changes, the "Notification MIB" used by SNMP TRAPS needs to be changed or does It keep unchanged?

1 REPLY
Cisco Employee

Re: Ciscoworks interaction with NETACT

Nope. The MIB (CISCO-EPM-NOTIFICATION-MIB) does not change. By configuring an Event Set, and adding only specific devices to your Notification Group, you are controlling which Events and Alerts gets sent as SNMP traps. However, the format of those traps will always be the same.

162
Views
0
Helpful
1
Replies
CreatePlease to create content