To schedule periodic config collection, go to RME > Admin > Config Mgmt > Collection Settings. The recommendation is to do config polling (looking for changes) nightly, and collection every week.
As soon as a device is added into RME, RME will perform an inventory collection. So inventory reports should be available almost immediately. To schedule periodic collection, go to RME > Admin > Inventory > System Job Schedule. A default schedule should already be setup for you for polling.
As for a limit, the short answer is yes, but it depends on your version and your license as to the actual device count limit.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...