Dear, all. We had crashed one of our hard disk on server last weekend. On this disk CiscoWorks was installed. Now after fixing and recovering from backup the software works but there is an issue with authorization. First of all when Home page of Common Services is open ACS mode link is highlighted with red colour and there is a message "Not all privileges assigned" when I open this link. The second issue is I can't see any device in RME. When RME home page is opened I see "JRM Service could be down. Check whether JRM services are running." but amount of devices shown is as many as 829. I guess second issue is consequence of first one. How can I see any debug/error messages appears during autorization process? And how can I fix both issues?
If you cannot figure out the ACS problems for there, I suggest you open a TAC service request. ACS troubleshooting can be quite tedious in this format, but if remote access is given, these types of problems can usually be solved quite quickly.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...