We are looking for a way to identify users in our 24 floor building on a 'per floor' basis. Is there a way (keep in mind we use DHCP addressing) to identify ONLY users from a specific floor that are on their edge switch? I have access to some tools that will do a network discovery, but obviously they pull data from all floors on all switches. Someone thought that maybe there was an app in CW2K that might be able to help. True or no?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...