Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Ciscoworks LMS 2.51 & Netscout nGenius Server

Hi,

I installed Ciscoworks LMS 2.51 & Netscout nGenius Server at the same server and installed Netscout nGenius Server first. When I installed DFM 2.0.3 and finished, it tell me there have some problem with Netscout nGenius Server ( seems the snmp trap conflict ), and ask me to check "LMS 2.5 readme". But I checked this readme file, no topic related with this problem. Can you give me some suggestion to solve the problem?

Best Regards,

1 REPLY
Cisco Employee

Re: Ciscoworks LMS 2.51 & Netscout nGenius Server

The issue with the RTM and DFM on the same server is the following bug: CSCdt62297: 'RTM and another trap receiver application cannot coexist.'

There is a workaround though:

If you install RTM and another trap receiver application (such as Device Fault Manager) on the same server, you must configure each

application to receive traps properly. By default, RTM listens on port 162.

To change the setting so that RTM is not the primary listener application:

In RTM:

Step 1: Stop the nGenius Server.

Step 2: Open the file /RTMROOT/rtm/bin/ngeniusnative.properties.

Step 3: Change this line:

devicelistener.portlist=162,395

to:

devicelistener.portlist=395

Step 4: Save and close the ngeniusnative.properties file.

Step 5: Restart the nGenius Server.

144
Views
5
Helpful
1
Replies