I currently have several Cat45k switches in Common Services\Device Management. I am trying to add a new switch of the same model. I've entered the correct credentials - hostname, ip address, username, passwords, SNMP strings. the new device show up with a ? on it, which means "Unknown". Is there a log where I can check why it's not discovered/recognized correctly? thanks.
Common Services does not contact devices. In order for the device to become known, one of the other applications needs to manage it (i.e. RME, Campus, etc.). So, make sure the device is synced to one of these applications, and that application should update DCR accordingly.
that's interesting. I thought devices are added to Common Services then you can see them in RME or Campus.
I added the device in Common Services. It's also shown with a ? in RME Device Management. I used the Check Device Credentials in RME to verify and failed. All fields came back "Device Not Supported". again I have several of these exact model switches in inventory.
I deleted the device and try to add it in RME and this is the error I get.
There are no new devices in DCA. Click here to add devices in DCA. On clicking, the current window will close and Common Services > Device and Credentials > Device Management screen
You will need to upgrade to Common Services 3.0.6 and RME 4.0.6 to get support for this device. Once on 4.0.6, go to Common Services > Software Center > Device Update, and download and install all updates for both Common Services and RME. In the end, you'll have Cat4000IOS package version 3.2, and the 4506-E will be supported.
I am unable to go through the gui to download upgrades, can you tell me which packages I need to support the 4506-E? I am currently on RME 4.0.6 and CS 3.0.6, my version of 3.0 for RME and 13.0 for CiscoView.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...