cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1018
Views
5
Helpful
3
Replies

Ciscoworks LMS 2.6 and Internet Explorer 7.0

enaforhmd
Level 1
Level 1

Hi,

When using Internet Explorer 7.0 to access to LMS 2.6.

An error message saying : Certificate Error , is displayed.

how can I fix the problem.

Best Regards.

Mustapha Djamel Eddine YAKHLEF

ENAFOR - Algeria

1 Accepted Solution

Accepted Solutions

Joe Clarke
Cisco Employee
Cisco Employee

IE 7.0 is not supported with LMS 2.6. IE 7.0 support was not added until LMS 3.0. As for certificate errors, you will generally get some kind of certificate warning with any browser you use since LMS uses self-signed certificates by default. Since these certificates are not signed by a trusted CA, the browser warns you that unless you trust the signer, you should not visit that site. In essence, if you trust yourself, you can disregard the message, and continue on.

View solution in original post

3 Replies 3

Joe Clarke
Cisco Employee
Cisco Employee

IE 7.0 is not supported with LMS 2.6. IE 7.0 support was not added until LMS 3.0. As for certificate errors, you will generally get some kind of certificate warning with any browser you use since LMS uses self-signed certificates by default. Since these certificates are not signed by a trusted CA, the browser warns you that unless you trust the signer, you should not visit that site. In essence, if you trust yourself, you can disregard the message, and continue on.

Thank you for your advice.

mukthar786
Level 1
Level 1

hi,

you can use Netscape Navigator for LMS 2.6

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: