When opening RME i get an error: Could not get database connection. Make sure that RME DB server is running. Check RMEHome.log for more details.
I also get the error "JRM Service could be down. Check whether JRM services are running." None of my devices are showing up.I have attached the RMEHome.log. Any help troubleshooting this would be appreciated. I have stopped and started the crmdmgtd service... nothing changes. I also have included the out output of pdshow.
Sure, a corruption can occur due to an improper shutdown of the daemons (server crash or not properly shutdown). Performing an upgrade can also cause some corruption if not done properly on Windows systems mostly. See both documents below which cover some of these causes in more detail:
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...