I have CW LMS 2.6 and I want monitoring my network with the CW.The CW send me a lot of messages that I don't need.In this moment I only need CW send me 1 message when a device up or when a device down, but in the message that the CW send me should have only :
I assume you're using DFM to generate email messages about device state. If so, you can restrict the number and type of email messages being sent, but you will not be able to adjust the format or content of the messages.
If all you are about are messages which indicate if a device is up or down, go to DFM > Notification Services > Event Sets, and check the box next to OperationallyDown under the 'A' column. Then go to DFM > Notification Services > Notification Groups and create a new group. Select the devices for which you wish to receive notifications, and check the Critical and Information boxes under Event Severity, and check the Active and Cleared boxes under Event Status. Select A from the Event Set pull-down. Then complete the wizard.
Finally, go to DFM > Notification Services > E-Mail Notification, and add a subscription to your newly created Notification Group.
You should now only receive emails when a device generates an OperationallyDown event, and when that event clears.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...